If your Baby Brezza SuperFast Steriliser Dryer is no longer blowing warm air and your bottles are still wet after a drying cycle, there are a few common causes that may be affecting its performance.
Possible Cause:
Water may have entered the drying vent, which can prevent the heating element from functioning properly. This usually happens when:
- Water is accidentally poured toward the vent during draining.
- The heating plate is dirty or has mineral buildup, causing boiling water to bubble over into the vent during use.
What You Can Do:
- Clean the Heating Plate:
- Make sure the heating plate is free of scale or residue.
- If you see white or brown residue, clean it with a 1:1 solution of white vinegar and water or the Baby Brezza Universal Descaling Tablets. Let it sit for 30 minutes, then wipe clean.
- Check the Drying Vent:
- If water has entered the vent, the internal components may have been affected.
- Unfortunately, this kind of damage can prevent the dryer from heating properly.
- Drain the Unit Properly:
- Always drain away from the vent, as shown in the instruction manual. Pouring in the wrong direction may allow water to flow into the internal vent system.
- Let It Fully Dry:
- If you suspect minor water entry, unplug the unit and allow it to dry for 24–48 hours in a well-ventilated area before testing again.
Additional Tip:
Check if your filter is clogged, airflow can be restricted, which also results in poor drying performance. The filter can be rinsed under running water
